三层电梯的plc设计

乘客电梯的PLC控制008 双击自动滚屏 文章来源：一流设计吧 发布者：16sheji8 发布时间：2008-9-12 9:36:25 阅读：522次 乘客电梯的PLC控制 摘要：国民经济的飞速发展, 现代化程度日益提高,高层建筑愈来愈多, 电梯也随之增多, 电梯产品在人们物质文化生活中的地位得到了提高,成为重要的运输设备之一。国内传统的电梯控制一是由继电器、接触器构成。它不仅存在着可靠性差、成本高、故障率高等缺点,而且在层数增加时,配线变化给制造及安装带来诸多不变。若用PLC 控制就解决了以上的不足。本设计就以PLC作为工具对升降电梯的各种操作进行控制。先对四层电梯的硬件部分作分析，看需要什么样的开关，电机，信号灯等。然后，画出它的控制面板图，再根据控制面板图估计一下I/O点数，这样可以确定所选机型，然后在软件设计，写出流程图，梯形图，写出语句。最后是进行调试，看看此程序是否可行。关键词：PLC控制系统 电梯 继电器 接触器 PLC control of passenger Elevator Abstract: The rapid development of the national economy, the increasing degree of modernization, more and more high-rise buildings, elevators also will be increased, Elevator products in people's material and cultural life of the status has been enhanced to become one of the important transport equipment. Traditional domestic elevator control from the first relay, a contactor. It is not only poor in the reliability, high cost, high failure rate shortcomings, but also in layers increases, changes to the wiring and installation of manufacturing has brought many unchanged. If the control by PLC to address the above shortcomings. the design of the PLC as a tool to the elevators for various operating control. Elevator on the first four parts of the hardware analysis, the need to see what kind of switches, motors, lights, etc.. Then, the control panel draw maps, plans, under the control panel is estimated to I / O points, so certain selected models, and then softwaredesign, write flowchart, ladder diagram, write statements. Finally,debugging and look at the feasibility of this procedure. Key words: PLC control system Elevator relay contactor 目录 第一章 引言1 第二章 概 2 本文来自: 一流设计吧(www.16sheji8.cn) 详细出处参考： http://www.16sheji8.cn/onews.asp?id=1236